How to Use Ceramic Motor Seal?
Leaks on head gasket happen when the engine overheated and this can be an expensive repair to make. But don’t worry because there’s an easy alternative for that and it is through the use of ceramic motor seal. Cylinder head gasket leaks are really a problem which causes plague in the internal combustion engine no matter what its model, make or year. It doesn’t matter if it is due to high mileage, tear and wear or engine overheat, leaks in the cylinder head gaskets can spell serious trouble.
When the cylinder head gasket starts to leak, this indicates that there’s a leak in the engine coolant, either to the crankcase of the engine or into several cylinders of the engine. It is highly recommended that you check out this site to learn a lot of things about it.
As for the severity of leaks in your head gasket, it can be minor to serious. In the former, the car is still in a driveable condition but it will suffer from diminished engine performance, overheating and slow coolant consumption. But when you have a serious issue with the leaks, then the engine has higher probability of suffering from major engine performance problems and overheating, blow white smoke out the tail pipes and excess coolant contamination. In a more severe case, the head gasket leak renders the car not suited for driving and need total engine replacement. It’s okay not to immediately deal with the leak on your head gasket, but be ready with the consequences, you can view here.
The Irontite works by means of sealing the engine’s head gasket leaks from within by using the cooling passages of the car and transport the sealer to where the leak is. To know the real problem of your car, it is best to contact a technician first and have them check your engine before you push through with the solution.
Assuming that everything is a go, here are few of the things that you must do.
#1. Read the instructions written at the back of Thoro-Flush to get a clearer idea on how it should be used.
#2. Find the radiator cap and pour in the engine block sealer straight to the engine.
#3. Get a new cap and put only the right amount of engine block sealer to the coolant.
#4. Start your engine and turn on your heater to maximum flow and heat.
#5. Keep your engine in idle as per the instruction on the engine block sealer.
These steps will get your car’s engine running in good condition, so do this now!